Configuring Cisco Devices for USB Audio with Xilica
When connecting a Cisco video bar or codec to a Xilica processor via USB audio, additional configuration is required on the Cisco device. By default, Cisco uses asynchronous USB audio, which is not compatible with Xilica processors.
Why This Configuration is Needed
Cisco video bars and codecs default to asynchronous USB audio mode. Xilica processors only support synchronous USB audio. Without changing this setting, the USB audio connection between the two devices will not function correctly.
Additionally, Cisco devices have built-in Acoustic Echo Cancellation (AEC) enabled by default. When using a Xilica processor for audio processing, AEC should be handled by the Xilica DSP instead. Running AEC on both devices simultaneously can cause audio quality issues such as double processing, signal cancellation, or reduced intelligibility.
What You Need to Change on the Cisco Device
Two settings must be adjusted on the Cisco device:
Setting | Default (Cisco) | Required for Xilica |
|---|---|---|
USB audio mode | Asynchronous | Synchronous |
Internal AEC | Enabled | Disabled |
1. Switch USB Audio to Synchronous Mode
On the Cisco device, change the USB audio mode from asynchronous to synchronous. Refer to your Cisco device's administration guide for the specific setting location. This is typically found under Audio Configuration or USB Settings in the Cisco device's web interface or touch panel settings.
2. Disable Internal AEC on the Cisco Device
Disable the built-in AEC on the Cisco video bar or codec. Once disabled, the Xilica processor will handle all echo cancellation processing.
Important: Only disable Cisco's internal AEC when the Xilica DSP is configured to provide AEC for the room. Without AEC running on either device, echo will be audible to far-end participants.
Xilica Configuration
On the Xilica processor, ensure the following:
The USB audio input and output is routed correctly in your Xilica Designer project
AEC processing is enabled and properly configured in the Xilica signal chain to replace the Cisco device's built-in echo cancellation
Microphone inputs feeding the AEC block have the correct reference signal from the Cisco device's far-end audio
Summary
Device | USB Audio Mode | AEC |
|---|---|---|
Cisco video bar / codec | Set to synchronous | Disabled |
Xilica Solaro processor | Synchronous (default) | Enabled, handles AEC for the room |
